Cisco Router Ethernet 10Mbps 1-Port ISDN BRI 1602 w/ 4mb Flash W/ WIC 1DSU 56k

%C1600-4-BADINTFC: Interface 2, (0-1 Onboard interfaces 2=WIC)
Invalid interface (Unknown, Uninitialized or Bad Cookie value read)
%C1600-4-INTFCNOFLH: Unable to load images or communicate over interface
%SYS-4-CONFIG_NEWER: Configurations from version 11.3 may not be correctly under
stood.
%QUICC_ETHER-1-LOSTCARR: Unit 0, lost carrier. Transceiver problem?program load
complete, entry point: 0x8000060, size: 0x3f5f2c

Restricted Rights Legend

Use, duplication, or disclosure by the Gov
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.

cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706



Cisco Internetwork Operating System Software
IOS (tm) 1600 Software (C1600-Y-L), Version 11.3(5)T, RELEASE SOFTWARE (fc1)
Copyright (c) 1986-1998
Compiled Wed 12-Aug-98 04:15 by ccai
Image text-base: 0x08023A14, data-base: 0x02005000

cisco 1602 (68360) processor (revision C) with 1536K/512K bytes of memory.
Processor board ID 11408841, with hardware revision 00000000
Bridging software.
X.25 software, Version 3.0.0.
1 Ethernet/IEEE 802.3 interface(s)
2 Serial network interface(s)
On-board Switched 56K Line Interface.
WIC with 56k 4-wire CSU/DSU
System/IO memory with parity disabled
2048K bytes of DRAM onboard
System running from FLASH
8K bytes of non-volatile configuration memory.
4096K bytes of processor board PCMCIA flash (Read ONLY)

% WARNING - auto rate will not work in back-to-back DDS.


Press RETURN to get started!


00:00:16: SERVICE_MODULE(Serial1): self test finished: Passed
*Mar 1 00:00:25.081: %LINK-3-UPDOWN: Interface Ethernet0, changed state to up
*Mar 1 00:00:25.105: %LINK-3-UPDOWN: Interface Serial0, changed state to down
*Mar 1 00:00:25.129: %LINK-3-UPDOWN: Interface Serial1, changed state to down
*Mar 1 00:00:25.788: %QUICC_ETHER-1-LOSTCARR: Unit 0, lost carrier. Transceiver
problem?
*Mar 1 00:00:25.792: %LINEPROTO-5-UPDOWN: Line protocol on Interface Ethernet0,
changed state to down
*Mar 1 00:00:25.792: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0, c
hanged state to down
*Mar 1 00:00:25.796: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial1, c
hanged state to down
*Mar 1 00:00:27.470: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial1.1,
changed state to down
*Mar 1 00:00:28.022: %LINK-5-CHANGED: Interface Serial0, changed state to admin
istratively down
*Mar 1 00:00:28.383: %SYS-5-CONFIG_I: Configured from memory by console
*Mar 1 00:00:28.391: %SYS-5-RESTART: System restarted --
Cisco Internetwork Operating System Software
IOS (tm) 1600 Software (C1600-Y-L), Version 11.3(5)T, RELEASE SOFTWARE (fc1)
Copyright (c) 1986-1998 by cisco Systems, Inc.
Compiled Wed 12-Aug-98 04:15 by ccai